AutoPatch 8Y-XL Setup Guide download pdf (Page 17)

Unpacking Tips

Before fully unpacking the enclosure(s), examine the shipping

box(es) for any signs of damage. If a box is partially crushed or any

sides have been broken open, notify the shipping agency

immediately and contact your AutoPatch Salesperson or

Representative.

Once unpacking is complete, closely check the physical condition of

the enclosure(s).

Collect all documentation and envelopes.

Note: AutoPatch is not responsible for damage caused by insufficient

packing during return shipment to the factory. Upon request, AutoPatch

will supply new shipping boxes at cost.

1.1 Front of the Enclosure

Enclosures are the structural basis of an 8Y-XL Distribution Matrix.

Since AutoPatch matrix switchers are custom-built for each installation,

factors such as control method, signal type, and potential switches affect

the appearance and weight of each enclosure.

An enclosure can have a blank front panel or a CP-10 Control Panel (a

front panel that is produced by AutoPatch and has an LCD screen and

keys for entering commands). Although a CP-10 Control Panel is

optional, we recommend one on at least one enclosure in the system for

system verification, redundant control, and troubleshooting. The CP-10

Control Panel can be attached or removed as needed.

1-2 Installation and Setup Guide

Unpacking the 8Y-XL

Unpacking

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 82 83

No comments

AutoPatch 8Y-XL Setup Guide Page 17