AutoPatch 8Y-XL Setup Guide download pdf (Page 43)

7.2 Executing a Test Switch Using BCS

Commands

The following test switch routes Input 1 to Output 2 on Level 0. Before

executing these switches, make sure the first two inputs and outputs are

connected exactly as shown in the AutoPatch “Modula Connector and

Groupings Guide.”

To execute a test switch, enter the following BCS command line into a

serial terminal program attached to the matrix:

CL0I1O2T

For a complete list of BCS commands, see Appendix C in the back of

this guide.

If the switch did not execute properly:

Check all power switches to make sure the source and destination

devices are turned on.

Check all link and signal connections on the rear of the enclosure(s)

to make sure everything is physically set up properly.

Attempt the switch again.

If the switch still does not work, call AutoAssist (see Technical Support,

page v).

7-4 Installation and Setup Guide

Executing a Test Switch

Test Switch

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 82 83

No comments

AutoPatch 8Y-XL Setup Guide Page 43