AutoPatch 8Y-XL Setup Guide download pdf (Page 40)

Executing a Test Switch

Execute a test switch to verify the system is working properly before

attaching all inputs and outputs. Aside from having signal cables

attached, the system is ready to perform switches when it ships from the

factory.

You can execute a test switch from the following:

CP-10 Control Panel

An external serial controller (computer, AMX, Crestron, etc.)

via BCS (Basic Control Structure) commands

Note: Before executing a test switch, attach only the first two inputs and

outputs described in the AutoPatch “8Y-XL Connector and Groupings

Guide” that came with your system.

The CP-10 test switch example (see page 7-2) routes input 2 to output 1

on Level 0 (your system may have been programmed with a different

level). The BCS Command test switch (see page 7-4) routes input 1 to

output 2 on Level 0. Before executing these switches, make sure the first

two inputs and outputs are connected exactly as shown on the AutoPatch

“8Y-XL Connector and Groupings Guide.”

Installation and Setup Guide 7-1

Test Switch

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 82 83

No comments

AutoPatch 8Y-XL Setup Guide Page 40