AutoPatch 8Y-XL Setup Guide download pdf (Page 23)

Placing the Enclosure(s)

You can install 8Y-XL enclosures in a standard EIA 19 in. (48.26 cm)

rack. To hold enclosures in place, they are shipped with rack installation

ears already attached.

To make control panel operations easier, mount the enclosure with the

CP-10 Control Panel attached in the rack at eye level. The optimum

viewing angle for the LCD screen is 15°. Install a multi-enclosure system

with all the enclosures linked, so control information can travel between

them.

Caution: Avoid placing high heat-producing equipment directly above

or below the enclosure(s). 8Y-XL enclosures are designed to adequately

dissipate the small amount of heat they produce under normal operating

conditions; however, this design is defeated when high heat-producing

equipment is placed directly above or below the enclosure(s).

Tools you will need to place enclosure(s):

Screwdriver

Screws that fit your rack [for mounting the enclosure(s)]

Link cables (included with multi-enclosure systems, otherwise not

needed)

Enclosure(s)

Standard EIA 19 in. (48.26 cm) rack

Surge protector(s) – highly recommended

Installation and Setup Guide 2-1

Placing

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 82 83

No comments

AutoPatch 8Y-XL Setup Guide Page 23