AutoPatch 8Y-XL Setup Guide download pdf (Page 63)

4. Line up the board assembly (switching board and daughter board)

with the board guides that are on the left and right of the board slot

(see graphic on the previous page). Carefully push the assembly into

the enclosure until the switching board snaps into place.

5. Insert the screws into the holes on the connector assembly and

tighten the screws until they are snug.

6. Attach the signals to the appropriate connectors (see Chapter 4,

“Attaching Inputs and Outputs”).

7. Reapply power and turn on the enclosure.

Note: If you are adding an audio board and want to adjust the gain, see

Chapter 9, “Adjusting Gain.”

Vertical Interval Timing Board

A Vertical Interval Timing board (sync board) provides the 8Y-XL with

complete vertical interval synchronization switching capability. The sync

board can utilize a master sync signal by separating sync from an input

signal (such as a composite video input) or can be used with a blackburst

generator.

Each enclosure in an 8Y-XL can contain one sync board. You may want

a sync board in each enclosure that switches video signals. If the system

was originally ordered with sync boards, they are already installed in the

enclosures.

Installation and Setup Guide 10-3

Adding Boards

Hardware

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 82 83

No comments

AutoPatch 8Y-XL Setup Guide Page 63